QMS SC-100 Guida di Configurazione Scaricare il pdf (Pagina 62)

9#

-

b Gently press the ribbon cable connector down until it’s fully seated.

▲ Caution:

Make sure that the connectors on the ribbon cable and the

controller board are properly aligned. Damage to the controller board could

result if the pins are misaligned.

c Insert the SCSI interface card connector into its opening in the interface

panel.

d Secure the SCSI interface card to the interface panel with the two larger

screws in the kit.

6 Reinstall the controller board.

Gently slide the controller board into the printer until it’s fully seated, and then

tighten the two screws.

7 Reconnect all interface cables.

8 Reconnect the power cord and turn on the printer.

9 Print a start-up page.

Check that the start-up page lists the interface just installed under “Options.”



1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 99 100

Nessun commento

QMS SC-100 Guida di Configurazione Pagina 62