QMS VMS Guida Utente Scaricare il pdf (Pagina 77)

6HOHFWLQJ

&KDUDFWHU6HWV

)RQW+DQGOLQJ

These designations remain in effect until you issue new designations

or mappings.

*UDSKLF6L]H6HOHFWLRQ*66

Use this sequence to set the character height of characters in the font

selected after this sequence.

Syntax: <ESC>P

<SP>C

The height of the characters implies the width of characters in the

font. The default value of

is 100.

For example, the following sequence selects an 8pt font:

<ESC>P80<SP>C

If an 8pt font has not been downloaded to the printer, the next greater

size font will be selected.

*UDSKLF6L]H0RGLILFDWLRQ*60

Use this sequence to select a new character size expressed as a

percentage of the size selected by the previous GSS command in

the current font.

<SI> Maps the ASCII character set (G0) to the GL table.

This is the default setup for the printer.

<SO> Maps the ASCII character set (G1) to the GR table.

This is the default setup for the printer.

<ESC>} Maps the Supplemental character set (G2) to the GR

table. This is the default setup for the printer.

<ESC>| Maps the Finnish character set (G3) to the GR table.

Numeric value, expressed in units determined by

PUM and SSU, for the desired height of the

characters.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 137 138

Nessun commento

QMS VMS Guida Utente Pagina 77