QMS CrownCopy Guida di Configurazione Scaricare il pdf (Pagina 48)

341



























































# 

To use a QMS Kanji font SIMM you need





 An application (such as a word processing or desktop publish-

ing package) that supports both the Kanji fonts and PostScript

printing.





 If you’re using a Macintosh, the following Macintosh system

software:

– Macintosh OS 8.xJ





 If you’re using a PC, the following system software:

– If you’re using Windows, version 3.1J or later

– If you’re using DOS, version 5.0J or later

$.*





 Caution:

It's very important to protect the printer controller board and

SIMM from electrostatic damage. Before performing this procedure,

review the antistatic caution in “Antistatic Protection” on page 4-2. In

addition, always handle circuit boards by the edges only.

1 Turn off the printer, and then disconnect the power cord and

all interface cables from the printer.

2 Open the printer’s front

cover.

3 Slide the fuser unit out

slightly.

4 Loosen two screws

(one on each end of

the controller boatd panel)

and, using the tab on the

lower side of the panel,

pull the panel off.



1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 125 126

Commenti su questo manuale

Nessun commento

QMS CrownCopy Guida di Configurazione Pagina 48

Commenti su questo manuale