QMS 2425 Specifiche Scaricare il pdf (Pagina 39)

2SWLRQ DO

/RFDO7DON

,QWHUIDFH

,QWHUIDFHVDQG'DXJKWHUERDUGV

4 Attach the LocalTalk Interface card.

a Position the LocalTalk interface card so the port slides into

the opening you just created.

b Snap the LocalTalk interface card onto the 80-pin connector

on the controller board.

c Press down on the board gently until it is secured by the 80-

pin connector and by the plastic standoff post.

5 Replace the controller board.

Use the instructions in chapter 2 “Memory and System Software,”

the “Reinstalling the Controller Board” section, of this manual.

6 Secure the LocalTalk interface card to the printer with the

two screws you removed earlier.

7 Reconnect all interface cables and the power cord, and then

turn on the printer.

8VLQJ WKH2S WLR QDO /RFDO7D ON, QWH UIDFH

Connecting to the optional LocalTalk interface involves basically three

steps: assembling the proper interface cabling (use a LocalTalk-type

kit such as Farallon's PhoneNET, available from your QMS vendor),

...................................

..................

.......................................

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 227 228

Nessun commento

QMS 2425 Specifiche Pagina 39